Menu
Menu
Learn how to use the two PRF method we developed to overcome the aliasing method…
This video shows how to connect the cables, install the software, instal the probe and define the operating parameters in order to get a velocity profile in a water channel.
This video shows how to install the probes and use the UDOP software to realize 2D velocity profile measurements in a water channel, just after a step.
This video shows how to use the UDV 2D/3D simulation software in order to fixe the best geometry of the probes and to determine the expected spatial resolution.
An automated system logs control settings and experimental measurements, using hardware trigger signals to synchronize devices are shown in this video.
This apparatus and the ultrasonic measuring technique can produce measurements that are impossible with other techniques, and allow optimization and control of electrochemical technologies like liquid metal batteries.
The video presents a protocol for the conduction of bed-load sediment transport experiments where the moving particles are tracked by image analysis.
The experimental facility, the procedures for run realization and data processing, and finally some proof-of-concept results are presented here.
It is necessary to prepare the front layer of the wave guide before it insertion in liquid metal melt.
This video shows how to deposit a layer of solder on the surface of the wave guide using a standard solder iron.
The solder must contain a flux compatible with stainless steel, like ARAX flux.
